← Latest stories

NOVUS and INTAMSYS report PEEK cranial implant production in about four hours for $100

NOVUS reports producing a patient-specific cranial implant in about four hours for $100 using an INTAMSYS FUNMAT PRO 310 APOLLO and OSSFILA PEEK. The case does not establish regulatory approval or clinical outcomes.

INTAMSYS FUNMAT PRO 310 APOLLO high-temperature 3D printer
Image: INTAMSYS / NOVUS Life Sciences / 南極熊
SOURCE 南极熊

NOVUS Life Sciences reports that it produced a patient-specific cranial implant in about four hours at an estimated manufacturing cost of US$100, using an INTAMSYS FUNMAT PRO 310 APOLLO and OSSFILA PEEK. The reported print speed exceeded 100 mm/s.

NOVUS benchmarked this against a previous process of about 15 hours and US$1,000. An INTAMSYS case study also says NOVUS customers produced more than 2,000 implants on INTAMSYS machines in 2025. These are application figures supplied by NOVUS and INTAMSYS.

The case demonstrates manufacturing time and cost claims; it does not establish medical-device approval in any jurisdiction, patient suitability or clinical outcomes. Real-world use requires local regulatory compliance covering material, process, design and sterilisation.

Key facts

  • Reported production time was about four hours
  • Reported manufacturing cost was about US$100
  • The setup used a FUNMAT PRO 310 APOLLO and OSSFILA PEEK

Context

The case suggests high-temperature FDM could reduce time and cost for in-house patient-specific implant production.

Suggest a correction

4小时、100美元!NOVUS联合远铸智能,将PEEK定制化颅骨植入物制造成本“打下来”

Visit source
Find a story

Find the brands and technologies you follow.